THANKS TO THE BAIT SLINGERS IN SDB

GLASS PADDY · Nov-11-2009, 03:13 PM

Went hooping last night to Pnt.Loma in my budies 21 CC.We got to the bait barge,got some big sardines from the good guys,and sat there for about 20min and shot the shit. when we left I pushed off and my buddy turned the key and nothing .We started to drift south pretty fast so we started paddling hard to get to the barge.Any ways the short of it is the guys at Everingham Bros Bait Co went out of there way to try to get us going.They helped get us back to the trailer safley.Then they sent a guy that new his shit with out boards over to help us out at the ramp.Bottom line is the good guys at Everingham Bros hooked us up with more than just the best bait in the sea.Great customer service.I will gladly be spending my money with them.

Fishbones · Nov-11-2009, 04:29 PM

Are you the one with the Ficht motor, That was my son that helped you get the motor up at the ramp (Fishin4life).Did you check all the fuses today?

Trayscool · Nov-11-2009, 05:01 PM

Yea those guys are good people...

Bigfish69 · Nov-11-2009, 05:04 PM

Thats the way it should be,,,great service all around....Cool cats on the barge for sure!

69R

GLASS PADDY · Nov-11-2009, 08:11 PM

Quote:

Originally Posted by Fishbones

Are you the one with the Ficht motor, That was my son that helped you get the motor up at the ramp (Fishin4life).Did you check all the fuses today?

Yes that was us.We went through all the fuses again this morn,and it was the one he said it would be.Your son is a good guy he walked up and said hey Chris sent me, over can I help out?He said he had the same motor on his boat.and he heped us out big time.Its good to run into some good people on the water.

Fishbones · Nov-11-2009, 08:16 PM

Another problem that may come up is the trim limit switch.What will happen is you will be able to trim your motor down but not up.There is a switch on the tilt tube that will stick and will cause the motor to think it is full up.Glad he was able to help out.