Help

[triggerfish1970]

Was greasing my EXW4/02 yesterday and after servicing my end cap housing screw located at the lug harness ( part no 2, 6-32, 5/16long) came loose and cannot be tighten again anyone can help.

[sdangler]

Like it's stripped out? Seems like a small thing to send it back for; as long as the others are seated properly. I would just put a some thread lok or lock tite on the screw and once it's dry, I would grease the hole and see if I could get it to stay in there for the season.

Just make sure that the screw is in there and water is kept out. I didn't look to see if there's a helicoil in there or if it's machined, so your options are limited once you send it back in to the factory. They'll hook you up either way.

Mark